Interface: Division of Forestry - NDOT District 3 Connected Vehicle Roadside Equipment
Architecture Flow Definitions
device identification (Planned) Applicable ITS Standards
An identifier and device type designation that is used to uniquely identify a device in the Connected Vehicle Environment.
equipment control commands (Planned) Applicable ITS Standards
System–level control commands issued to the RSE such as reset and remote diagnostics.
local situation data (Planned) Applicable ITS Standards
This general flow represents the traffic, environmental, and emissions situation data that is collected from connected vehicles by an RSE, aggregated, filtered, and provided to a back–office center. It also includes data collected from ITS roadway equipment that provides current intersection and road network status for the area proximate to the RSE.
protected location and address flow (Planned) Applicable ITS Standards
Information flow that has had its geographic location information removed and network address information proxied to protect the privacy of the originator.
RSE application information (Planned) Applicable ITS Standards
RSE application configuration data and parameters that are used to control applications and configure the application for a specific local use. This flow also supports remote control of the application so the application can be taken offline, reset, or restarted.
RSE application install/upgrade (Planned) Applicable ITS Standards
This flow supports remote installation and update of software applications residing in the RSE. It supports transmission of the secure software installation files, including executable application code and associated support files.
RSE application status (Planned) Applicable ITS Standards
Monitoring of RSE application status including current mode, operational status, and configuration settings. It includes the status of installed applications and the application–specific data provided by the RSE.
traffic situation data (Planned) Applicable ITS Standards
Current, aggregate traffic data collected from connected vehicles that can be used to supplement or replace information collected by roadside traffic detectors. It includes raw and/or processed reported vehicle speeds, counts, and other derived measures. Raw and/or filtered vehicle control events may also be included to support incident detection.
traveler information application info (Planned) Applicable ITS Standards
Traveler information and associated parameters, filters, and thresholds that control the RSE's distribution of the traveler information to passing vehicles. This flow also supports remote control of the application so the application can be taken offline, reset, or restarted.
traveler information application status (Planned) Applicable ITS Standards
Application status reported by the RSE. This includes current operational state and status of the RSE and a record of traveler information distribution.