Interface: CVO Pre-Pass - Local/County Connected Vehicle Roadside Equipment
Architecture Flow Definitions
commercial vehicle disable status (Planned) Applicable ITS Standards
This flow provides the status of the disable flag in the commercial vehicle.
commercial vehicle identities (Planned) Applicable ITS Standards
Identification information for the Commercial Vehicle (e.g., license plate number or USDOT number), Freight Equipment (e.g., container, chassis, or trailer identification), Carrier, and Driver.
container seal status (Planned) Applicable ITS Standards
The status of an electronic seal on a container, indicating sealing time, location, and authority, and any openings or tampering.
driver log (Planned) Applicable ITS Standards
A daily log showing hours in service for the current driver. The query flow is not explicitly shown.
electronic lock data (Planned) Applicable ITS Standards
Notification to roadside (via transponder) of the presence and status of electronic cargo locks.
electronic lock data request (Planned) Applicable ITS Standards
Request from roadside for data regarding presence and status of electronic cargo locks.
electronic screening request (Planned) Applicable ITS Standards
Request for identification data to support electronic screening.
expected driver identity characteristics (Planned) Applicable ITS Standards
Driver identification information e.g., encrypted PIN codes issued to drivers, encrypted driver biometric parameters.
freight equipment information (Planned) Applicable ITS Standards
Container, trailer, or chassis information regarding identity, type, location, brake wear data, mileage, seal #, seal type, door open/close status, chassis bare/covered status, tethered / untethered status, temperature, humidity, power, battery levels, brake wear data, and bill of lading/information regarding the cargo/content.
on-board safety data (Planned) Applicable ITS Standards
Safety data measured by on–board sensors. Includes information about the vehicle, vehicle components, cargo, and driver. The query flow is not explicitly shown.
pass/pull-in (Planned) Applicable ITS Standards
Command to commercial vehicle to pull into or bypass inspection station.
safety inspection record (Planned) Applicable ITS Standards
Record containing results of commercial vehicle safety inspection.
safety inspection request (Planned) Applicable ITS Standards
Request for safety inspection record.
screening event record (Planned) Applicable ITS Standards
Results of CVO electronic screening activity.
trigger area notification (Planned) Applicable ITS Standards
Notification to activate wireless roadside inspection safety data message collection.
unique identifiers (Planned) Applicable ITS Standards
Unique identifiers for the motor carrier, driver, and vehicle. This flow identifies the driver actually operating the vehicle in multi–driver scenarios.